Water Network
Reduce losses, optimize pressure and improve safety and service reliability.
Capabilities
- Hourly Water Balance
Analyzes hourly water inflows, outflows, and customer consumption in each DMA, enabling early detection of water losses and unusual flow, pressure and consumption patterns within hours rather than at month-end.
- NRW & ILI
Calculates non-revenue water and the Infrastructure Leakage Index for each DMA, the standard measures utilities use to compare how much water is being lost against what's technically unavoidable.
- Leak & Burst Detection
Flags abnormal flow patterns that indicate a new leak or burst, so field crews can be pointed at a zone before a customer reports a problem.
- Customer-side Leaks
Identifies continuous or unusual consumption patterns at individual customer meters that indicate a leak on the customer's side of the connection, not the utility's.
- Backflow Management
Detects reverse flow events where water from customer installations flows back into the water distribution network, potentially compromising water quality and the safety of the water supply. Enables identification and monitoring of these events until the issue is fully resolved.
- Pressure Management
Monitors pressure across the entire water distribution network, identifying areas where pressure exceeds required levels. Helps identify zones at increased risk of pipe failures and leaks, while supporting pressure optimization to reduce water losses and minimize stress on water pipelines.
- DMA Analytics
Uses measurement data from devices defining the boundaries of individual water distribution zones to generate zone-level water balances, enabling the detection of water losses and anomalies that may remain hidden in the overall network water balance.
- Large Consumers
Monitors consumption from the network's largest customers separately, since a single large account's meter fault or unusual usage can otherwise be misread as a zone-wide loss.
- Hydraulic Modelling
Simulates how water moves through the network under different demand and pressure conditions, used to test the effect of a change before it's made in the field.